Allnet ALL9600R Instrukcja Użytkownika Pobierz pdf (Strona 10)

User’s Manual

(3) Function Test: Turn on your AV device, the POWER LED should turn

on green to indicate the POWER ON status and the LEDs above RJ-45

will blink before VGA signal is turned ON and remain ON after VGA

signal is turned ON.

2. Receiver ALL9600R installation and UTP Connection

(1) Site Selection: Please place Receiver in an appropriate place and have

the UTP cable settled for later connection.

(2) Power Up: Plug power adapter to the Receiver and connect monitor

and speaker to the VGA OUT and AUDIO port. The power LED will

turn on green to indicate the POWER ON status.

(3) Selection of UTP Cable: For best VGA resolution, please use Cat5

Enhanced cable (350MHz bandwidth) for connection, please note that

the maximum extended length of one section should not exceed 300

meters. The connector must be made by 568B/568B type.

The EIA/TIA denation of 568B in the pin assignment is

(1) orange white, (2) orange, (3) green white, (4) blue,

(5) blue white, (6) green, (7) brown white, and (8) brown

1 2 3 4 5 6 7 8

JACK POSITION

PAIR 1PAIR 2 PAIR 4

PAIR 3

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Brak uwag

Allnet ALL9600R Instrukcja Użytkownika Strona 10